Table of Contents
Advertisement
4.
Use (B) and (D) to change the hour setting.
Holding down (B) or (D) scrolls through
●
settings at high speed.
If you use 12-hour timekeeping, [AM]
●
indicates a.m. times, while [PM]
indicates p.m. times.
5.
Press (C).
This causes the minutes digits to flash.
Alarm minute
6.
Use (B) and (D) to set the minute setting.
7.
Press (A) to complete the setting
operation.
Note
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Testing the alarm
●
In the Alarm Mode, hold down (D) to sound the
alarm.
To stop the alarm
●
To stop the alarm after it starts to sound when
an alarm time is reached, press any button.
Note
A beeper will sound for 10 seconds to
●
let you know when the alarm time is
reached.
The watch will automatically return to
●
the Timekeeping Mode from the Alarm
Mode after two or three minutes of non-
operation.
Watch Operation Guide 3561
Configuring the Hourly Time
Signal Setting
1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Press (D) to display the hourly time signal
screen.
3.
Press (A) to toggle the hourly time signal
between enabled and disabled.
[
●
display while the hourly time signal is
enabled.
Turning Off an Alarm or the
Hourly Time Signal
To stop an alarm or the hourly time signal from
sounding, perform the steps below to turn it
off.
To have an alarm or hourly time signal
●
sound again, turn it back on.
Note
Indicators are displayed while any of
●
the alarms or the hourly time signal is
turned on.
The applicable indicators are not
●
displayed while all of the alarms are
turned off and/or the hourly time signal
is turned off.
] (hourly time signal) is shown on the
Hourly time signal
Alarm
1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Press (D) to scroll through the alarm
number ([1] to [5]) and the hourly time
signal screens until the one you want to
configure is displayed.
Alarm
Hourly time signal
Alarm number
3.
Press (A) to turn off the displayed alarm or
the hourly time signal.
Each press of (A) toggles between on
●
and off.
Turning off all alarms causes [
●
(alarm) to disappear from the display.
Turning off the hourly time signal
causes [
] (hourly time signal) to
disappear.
Note
If [
] (alarm) is still displayed after
●
you turn off an alarm, it means at least
one of the other alarms is still turned
on. To turn off all of the alarms, repeat
steps 2 and 3 until the [
indicator is no longer displayed.
]
] (alarm)
9
Advertisement
Table of Contents
