Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
Setting the Time
The countdown start time can be set in 1-
minute units up to 24 hours.
If a timer countdown operation is in
●
progress, reset the timer to its current start
time before performing this operation.
Using the Timer
l
1.
Enter the Timer Mode.
Navigating Between Modes
l
2.
Hold down (A) for at least one second.
This causes the hours digits to flash.
Hours
3.
Use (B) and (D) to change the timer hours
setting.
Holding down (B) or (D) scrolls through
●
settings at high speed.
4.
Press (C).
This causes the minutes digits to flash.
Minutes
Watch Operation Guide 3561
5.
Use (B) and (D) to change the timer
minutes setting.
6.
Press (A) to complete the setting
operation.
Note
While the setting is being configured,
●
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Setting a start time of "0:00" will
●
perform a countdown of 24 hours.
Using the Timer
1.
Enter the Timer Mode.
Navigating Between Modes
l
2.
Use the operations below to perform a
timer operation.
A beeper will sound for 10 seconds to
●
let you know when the end of a
countdown is reached.
You can reset a paused countdown to
●
its start time, by pressing (A).
3.
Press any button to stop the tone.
Hour, minute, second
D
Start
(Countdown starts)
D
Pause
D
Resume
(Time up)
Other Settings
This section explains other watch settings you
can configure.
Enabling the Button
Operation Tone
Use the procedure below to enable or disable
the tone that sounds when you press a button.
If a setting screen (flashing setting) is
●
displayed or if an alarm or other beeper
operation is in progress, exit the setting
screen or wait until the beeper operation is
finished before trying to configure this
setting.
1.
Hold down (C) for at least three seconds
to toggle the operation tone between
enabled and disabled.
[
] is displayed while the button
O
●
operation tone is disabled.
Pressing (C) to perform this operation
●
also changes the watch mode.
Note
Note that alarm and timer tones will still
●
sound even while the operation tone is
muted.
11