Table of Contents
Advertisement
3
1
2
1
Press the POWER switch.
The unit enters standby mode, and the standby indicator
lights.
2
Press the STANDBY/ON switch to turn the unit on.
The power indicator lights, and the standby indicator goes
off.
3
Select a source by turning the FUNCTION knob (or
pressing one of the FUNCTION buttons of the remote
control unit).
TUNER*
VIDEO 3
*: frequency is displayed.
The selected source is shown on the front panel's display.
< If one of the FUNCTION buttons or EXT IN button of the
remote control unit is pressed in the standby mode, the unit is
turned on with the selected source automatically.
< If the source is connected to EXTERNAL IN jacks, press the
EXTERNAL IN button and proceed to step
26
Basic Operation 1
4
5
CD
AUX
TAPE
VIDEO 2
VIDEO 1
5
.
4
When you selected VIDEO(1, 2 or 3) or CD in step
press the DIGITAL INPUTS button repeatedly to select
the terminal.
o1: Select this when the source is connected to DIGITAL IN
(OPTICAL 1) terminal.
o2: Select this when the source is connected to DIGITAL IN
(OPTICAL 2) terminal.
c1: Select this when the source is connected to DIGITAL IN
(COAXIAL 1) terminal.
c2: Select this when the source is connected to DIGITAL IN
(COAXIAL 2) terminal.
A: Select this when the source is connected to analog
AUDIO IN jacks.
< DIGITAL indicator blinks when the unit cannot perceive the
digital signal. In that case, connect a digital device to the
DIGITAL IN terminal, switch it on, and select the terminal by
pressing the DIGITAL INPUTS button.
< You can hear the sound from the selected DIGITAL IN
terminal as far as VIDEO (1,2 or 3) or CD has been selected in
3
step
.
5
Play the source, and gradually turn up the volume to
the required level by turning the VOLUME knob.
3
,
Advertisement
Table of Contents
