Roland G-800 Reference Manual page 87

MIDI mode, MIDI on your G-800
E Filter
This parameter allows you to select several MIDI messages and to specify for each of them
can filter are:
MIDI message
Meaning
Modul Modulation messages (CC1)
Volum Volume messages (CC7)
PanPt hi Pan(pot) messages (CC10)
Expre Expression messages (CC11)
Hold | Hold (Sustain, Damper) messages (CC64)
Sostn | Sostenuto messages (CC66)
Soft | Soft messages (CC67)
Revrb Reverb Send messages (CC91)
Chrus Chorus Send messages (CC93)
Delay
Delay Send messages (CC94)
Assignable control
Registered parameter number (CC100/101)
Non-registered parameter number (CC98/99)
SysEx messages (system exclusive)
E Limit (High, Low: C-1~G9)
These parameters (High and Low) allow you to set the note range to be received. If not all
note messages on the selected MIDI channel should be received by the selected part, set the
range to the desired values.
To set the upper limit (High), first press Part Select [UPPER 1] until the message below the
on-screen knob reads Hi Sh. To set the lower limit, press Part Select [UPPER1] to select Low
before setting the value with the [UPPER/VARIATION] knob.
85