Panasonic Omnivision PV-9405S Operating Instructions Manual page 5

1 Between ANT. and VCR
@ Case 1: Twin Lead Cable Only
To VCR Terminal
From Antenna
300-75 ohm
Transformer
(not supplied)
pn
(Flat) Twin Lead
300 Ohm Cable
Ш Case 2: Twin Lead & Coaxial Cables
=a
UHF/VHF Band Mixer
(not supplied)
(Round) 75 Ohm
coaxial Cable
To VCR Terminal
Ш Case 3: Two Twin Lead Cables
pp
UHF/VHF Band Mixer
(not supplied)
| 300-75 ohm
Transformer
(not supplied)
To VCR Terminal
* |f your TV has both post and plug-type
VHF terminals, the post connection is
recommended to minimize signal loss.
2 Between VCR and TV
Ш Case 1: Screw & Plug Type Terminal
UHF/VHF Band
Separator
(not supplied)
UOIJD 21529
RF Coaxial Cable
M Case 2: Screw Type Terminal
75-300 ohm
Transformer
(not supplied)
UHF/VHF Band
Separator
(not supplied)
Ш Case 4: Complex TV Terminal
TERMINALS ON BACK OF TV SET
Split out
ANT1
* Connect to one of the ANT terminals and
select the same antenna number on the TV.