Kenwood AR-404 Instruction Manual page 15

Remote contro! unit
Remote control operation is not | * Botteres se extousted 'feplace with now batteries. CE)
possible.
'The remote contol unit isto tar away | *Operate the remote conta unt within
from the main system. controing angie | the controlabierenge.
1 too large, oF there is on obstacle bo
{boon the receiver and the remote
~Trenuiocosardaytemconvotcods | Cones mopety ering ating
'ate not connected propery 'up the system" +
'No software ie loaded in the source | «Place sofiwarainthe source component
'eomponnt you want 10 pay
Pn a ec)
[Sassen sa
Memory back up function
For USA aed Canad
Pease note thatthe fotowng items willbe deleted fom
{he unit's memory the power cord disconnected tram
{he AC outlet for approximately 3 days.
'Except for USA. and Cosada
Piase not that the folowang tems wl be deleted trom
'he unit's memory he power cordishsconnected fom
{he AC outlet ot the main power swatch is tumed of for
sppronmately 3 days
+ Power mode
'put selector settings
Volume level
For the U.S.A.
FCC WARNING
'This equipment mey generate or use rato frequency energy. Changes of modifications to this equipment may cause harmful
'sterfrence unless the madiicstons are expressly approved inthe Instruction manuel. The vser coud love the authorty to
'Operate ths equipment fan unauthozed change or madieation is mae
NOTE:
'This equipmenthas boon tested and found to comply with the mits fora Class 8 digital vice, pursuant to Pat 15 of the FCC
ules. These nits ae designed 1 provide reasonable protection against harmful interference in reaental mstalaton. Ths
'equipment may cause harmful interference to radio communications, If is not installed and used i accordance with the
instructions. However, theres no uaantee that imerference wil not occur in 8 particular installation. 1 ths equipment does
'cause harmful interference to racso or television reception, which can be determined by turmng the egpment off ad on the
User is encouraged to ty to correct tho interference by one oF more ofthe following measures:
'Reorent or relocate the receing antenna,
increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a ccutcferent from that to wich the recover i connected
Consult the desler or an experianced rado /TV technician for hap.
'Note to CATV system installer:
'This reminder is provided to call the CATV system installer' attention to Article 620-40 of the NEC that provides guidelines
{or proper grounding and. in particular, species thatthe cable ground shall be connected to the grounding system of the
bailing a close tothe point of cable entry as practical,