Kenwood AR-404 Instruction Manual page 14

'Resetting the Microcomputer
If the microcomputer may malfunction (unt cannot be
'operated or shows an erroneous dispiay ifthe power cord
'unplugged wile the power is ON, oF due to some other
fextoma factor If this happens, exacute the folowing pro
'cedure toreset the microcomputer
and return the unit tots
'normal operating condition
For USA ond Canad
Except loc USA sad Canada
'With the power cord pluggedin, ture the POWER key
OFF. Then, while holding down the ON/STANDBY
'kay, prose the POWER key.
'Pionse note that resetting the mcrocomputer will lear
'the contents of the memory and returns the unt tothe
'State was 6 when fief the factory
tin.
"MUTE is On
'a disconnected.
1 The SPEAKERS swiches ae sotto OFF
'Turn OFF the MUTE
the SPEAKERS swcion to Ol
* Turn the powe of, eliminate the shor
terminal on the rear panel. C8)
Tuner
not tuned.
'No antenna is connected
'The broadcast band snot set properly.
{The frequency of he dosved stavonis | + Tune the frequency ofthe desired st
'Connect an antenna 2
1 Set the broadcast band propery.
von
mobile.
ne appliance.
'Noise dv0 10 8 nearby TV set
'the road
'+nstalthe receiver farther away fom the
wv
be received by pressing the corre-
sponding numeric key: