Canon MV430 Instruction Book page 93

When you play back a tape that was recorded in 12-bit mode, you can set the
audio output to play: stereo 1 (the original sound), stereo 2 (any new sound,
dubbed to the tape after recording), or mix the balance between the two.
♦ Audio from the 16-bit mode only contains stereo 1 sound and so you cannot/do
not need to select the audio mix. The same is true for the 12-bit stereo 1 mode,
unless new sound has been added post-recording.
PLAY
+(EEEED)
1. Choose the output.
• Press AUDIO MONITOR on the wireless controller.
• Starting with the last selected setting, 4 settings appear as you push the
button:
- STEREO 1 for just stereo 1.
- STERE02 for just stereo 2.
- MIX/FIXED for an equal mix of stereo 1 and 2.
- MIX/VARI. (mix variable) for when you want to mix the balance between
stereo 1 and 2.
• To simply choose STEREO 1, STERE02 or MIX/FIXED, make sure your
choice appears on the display.
• If you choose MIX/VARI., you can go on to mix the balance.
• Use the ST-l/ST-2 keys to mix the balance. A bar showing the mix appears
on the screen for 4 seconds.
TAPE
B
Note;
• When you have chosen the output, STEREO 1, STERE02, MIX/FIXED or
MIX/VARI. is shown in the top left of the display for a few seconds. If you turn
the power off the output is set to STEREO 1.
93