Loading A Cassette - Canon MV430 Instruction Book

Loading a Cassette
Only use videocassettes marked with the M,n'DvT logo.*
Loading and unloading
1. Make sure that you have attached a power source.
2. Slide the OPEN / EJECT ± switch (on the bottom of the
camcorder) to release the cassette compartment cover.
• Pull the cover fully open (while holding the button) and wait a couple of
seconds for the cassette compartment to open automatically.
• The confirmation beep sounds when the cassette cover fully opens.
3. Load or unload the cassette.
• Insert the cassette gently with the window facing the grip belt, and the
REC/SAVE tab up.
• Remove the cassette by pulling it straight out.
4. Press the
(push]
mark on the compartment until it clicks, and wait
for it to close.
5. Click the cover back into place.
• js a mark.
\M
Notes:
• Do not interfere with the cassette compartment while it is opening or closing
automatically, and do not attempt to close the cover until the cassette
compartment has fully retracted.
• After loading a cassette, use record search (QQ 53) to find the point where you
want to start recording.
• Be careful not to get your fingers caught in the cassette compartment cover.
• Do not leave the cassette in the camcorder after use — return it to its case and
store it in a cool, clean, dry place.
• When you turn the camcorder's power on, flashes in the display until you
load a cassette.
• With some types of tapes, the remaining tape display may not give an accurate
reading (QJ 137).
15