Cleaning Of Front Panel - Hitachi RAS-CH10PCAST Operation Manual

2.

CLEANING OF FRONT PANEL

Remove the front panel and wash with clean water.
●
Wash it with a soft sponge.
After using neutral detergent, wash thoroughly with
clean water.
When front panel is not removed, wipe it with a soft
●
dry cloth. Wipe the remote controller thoroughly with
a soft dry cloth.
Wipe the water thoroughly.
●
If water remains at indicators or signal receiver of
indoor unit, it causes trouble.
Method of removing the front panel.
Be sure to hold the front panel with both hands to
detach and attach it.
Removing the Front Panel
1. Push the end of the right-side arm outward
to release the right tab.
2. Move the left-side arm outward to release
the left tab and then pull the panel towards
you.
! CAUTION
Never use hot water (above 40°C), benzine, gasoline, acid, thinner
●
or a brush, because they will damage the plastic surface and the
coating.
Attaching the Front Panel
1. Insert the shaft of the left arm along the step
on the unit into the hole.
2. Securely insert the shaft of the right arm
along the step on the unit into the hole.
3. Make sure that the front panel is securely
attached an then close the front panel.
– 22 –