Sony DVP-NC85H Operating Instructions Manual page 68

4!,AUDIO (HDMI)
Selects the type of audio signal ontput from
the HDMI OUT jack.
AUTO
Nomlally, select this. Outputs
andio signals according to the
"DIGITAL OUT" settings
(page 69).
PCM Converts Dolby Digital, or
96 kHz_4 bit PCM signals to
48 kHzi16 bit PCM.
A loud noise (or no sound) will be output if you
connect the player to a TV that is not compatible
with DOLBY DIGITAL,'DTS signals and "AUTO"
is selected In this case, select "PCM."
Settings for the Sound
(AUDIOSETUP)
"AUDIO SETUP" allows you to set the sound
according to the playback and connection
conditions.
Select "AUDIO SETUP" in the Setup
Display. To use the display, see "Using the
Setup Display" (page 63).
The defauh settings are nnderlined.
4!, AUDIO ATT (attenuation)
If the playback sound is distorted, set this
item to "ON." The player reduces the audio
output level.
This fnnction affects the output of the LINE
OUT LiR (AUDIO) jacks.
OFF Normally, select this position.
ON Select this when the playback somld
from the speakers is distorted.
4!,AUDIODRC (Dynamic RangeControl)
(DVDVIDEO/DVD-VRmodeonly)
Makes the sound clear when the volume is
turned down when playing a DVD that
conforms to "AUDIO DR(."
This fnnction affects the output from the
following jacks:
LINE OUT LR (AUDIO) jacks
DIGITAL OUT (OPTICAL or (OAXIAL)
HDMI OUT jack on!y when "DOLBY
DIGITAL" is set to "D-P(M" (page 70).
STANDARD Nom_ally select this position.
TV MODE Makes low soundsclear even if
you turn the volume down.
WIDE Gives you the feeling of being
RANGE at a live perl\_rmance.
68