Sony DVP-NC85H Operating Instructions Manual page 25

7
Press '!'/4, toselect the setting that
matchesyour TV type.
If you have a 4:3 standard TV
• 4:3 LETTER BOX or 4:3 PAN S(AN
(page 65)
If you have a wide-screen IV or a 4:3
standard TV with a wide-screen mode
• 16:9 (page 65)
8 Press ENTER.
The Setup Display for selecting the type
of jack used to connect your amplifier
(receiver) appears.
AUDIO SETUP
11
Press ENTER.
"DTS" is selected.
&UD[O SETUP
o
9
Press 't,/4, toselect the typeofjack
(if any) you are usingto connectto
an amplifier (receiver), then press
ENTER.
If you did not connect an AV amplifier
(receiver), select "NO," then go to step
13.
If you connected an AV amplifier
(receiver) using just an audio cord, select
"YES: LINE OUTPUT L,R (AUDIO),"
then go to step 13.
If you connected an AV amplifier
(receiver) using a digital coaxial or
optical HDMI cord, select "YES:
DIGITAL OUTPUT."
10Press
'1"/4,to select the type of
Dolby Digital signal you wish to
send to your amplifier (receiver).
Ifyonr AV amplifier (receiver) has a
Dolby Digital decoder, select "DOLBY
DIGITAL." Otherwise, select "D-P(?M."
12Press
÷/4, to selectwhether or
notyou wish to send a DTSsignal
to your amplifier (receiver).
If your AV amplifier (receiver) has a
DTS decoder, select "ON." Otherwise,
select "OFF."
13Press E NTER.
Quick Setup is finished. All connections
and setup operations are complete.
25