Table of Contents
Advertisement
The operator is responsible for the safe operation of
this equipment. The operator must be properly trained.
Operators should be familiar with the equipment, the
tractor, and all safety practices before starting opera-
tion. Read the safety rules and safety decals on page 5
through page 9.
The box scrapers are designed for a wide range of ap-
plications: scarifying, scraping, leveling, grading, and
backfilling.
PRE-OPERATION CHECKLIST
(OWNER'S RESPONSIBILITY)
Review and follow all safety rules and safety
decal instructions on pages 5 through 9.
Check that equipment is properly and securely
attached to tractor.
Check that all safety decals are installed and in
good condition. Replace if damaged
Check that all hardware and cotter pins are
properly installed and secured.
Check that all lubrication points are greased.
Check that blade cutting edge is in good
condition.
Check that all hydraulic hoses and fittings are in
good condition and not leaking before starting
tractor. Check that hoses are not twisted, bent
sharply, kinked, frayed or pulled tight. Replace
any damaged hoses immediately.
WARNING
■ Due to the mass of the (mounted) machine it-
self and loaded materials, the tractor machine
combination can influence maneuverability and
stability. A mini mum 20% of tractor and equip-
ment weight must be on the tractor front wheels
when attachments are in transport position.
Without this weight, front tractor wheels could
raise up resulting in loss of steering. Without
this weight, tractor could tip over, causing
personal injury or death. The weight may be at-
tained with front wheel weights, ballast in tires,
front tractor weights or front loader. Weigh the
tractor and equipment. DO NOT ESTIMATE.
10 Operation
MAN1377_2024-02.indd 10
MAN1377_2024-02.indd 10
OPERATION
CONNECTING BOX SCRAPER
TO TRACTOR
The BSXX.20 and BSXX.30 models are compatible
with Category 1, 3-point tractors equipped with side
swing-type lower lift arms. BSXX.40 models are com-
patible with Category 1 and 2 3-point hitches.
To avoid interference with the box scraper, adjust trac-
tor drawbar to the shortest and highest position.
BSXX.20 Models
SLEEVE FOR
CATEGORY 1
QUICK HITCH
QUICK HITCH SLEEVE
1. Attach tractor's lower 3-point arms to scraper lower
hitch pin (9) and secure in place with klik pin (18).
2. Attach tractor top link to upper hole in A-frame bars
using tractor heavy-duty top link pin. Secure with
retaining pin supplied with tractor top link.
3. When using a Quick Hitch, install sleeve (10) on
lower pins and secure with klik pin.
4. Quick Hitch attaches to lower hitch pin sleeves and
sleeve between A-frame bars.
Figure 1. Tractor Stability
CATEGORY 1
TOP LINK
CONNECTION
18
9
10
CATEGORY 1
Figure 2. BSXX.20 Models
( 02/29/2024 )
CD1564-1
CD9400
MAN1377
2/29/24 9:00 AM
2/29/24 9:00 AM
Advertisement
Table of Contents
