Woods BS48.20 Operator's Manual page 16

1. SCRAPER FRAME
2. PLATE, MAST RT
3. PLATE, MAST LT W/ DECAL
9. SLEEVE, CAT 1 QUICK HITCH
21. HHCS, M16 X 2.0 X 50 CLASS 8.8
22. WASHER, 5/8 SAE FLAT HRDN
23. NUT, LOCK, 16MM
24. HHCS, M20 X 2.5 X 110 CLASS 8.8
25. WASHER, FLAT 20MM
26. NUT, LOCK, 20MM
BSXX.30, BSXX.40 Models
1. Remove frame, loose parts and hardware from
shipping crate.
2. Attach left mast plate (3) to scraper frame (1) using
cap screws (21), washers (22) and nuts (23).
3. Repeat step 2 for the right mast plate (2).
4. Locate sleeves (9) between mast plates lower
holes. Secure with cap screws (24), washers (25)
and nuts (26).
5. Torque hardware to recommended values shown on
page 26.
16 Assembly
MAN1377_2024-02.indd 16 MAN1377_2024-02.indd 16
26
25
9
2
21
22
3
1
22
Figure 9. BSXX.30, BSXX.40 Models
All Models
Early production models do not have scarifiers installed
for shipment. Locate scarifiers in shipping crate.
1. Block up scraper by placing two 6" x 6" (15.24 cm x
2. Lower scraper to rest securely on the blocks.
3. Remove safety pin and bent pin from scarifier
4. Install scarifier in the desired hole. Retain with bent
5. Repeat for remaining scarifiers.
25 23
22
24
23
15.24 cm) blocks under each side frame (see Figure
6).
NOTE: Do not block the scraper any higher than
necessary to install the scarifiers.
mount. (Figure 7)
pin and safety pin.
22
21
CD9404
MAN1377
( 02/29/2024 )
2/29/24 9:00 AM 2/29/24 9:00 AM