Table of Contents
Advertisement
DEALER SET-UP INSTRUCTIONS
Assembly of this Grading Scraper is the responsibili-
ty of the WOODS dealer. It should be delivered to the
owner completely assembled and adjusted for normal
conditions.
Complete the Checklists on page 17 before delivering
the attachment to the customer.
The Grading Scraper is shipped partially assembled.
Assembly will be easier if components are aligned and
loosely
assembled
Recommended torque values for hardware are located
on page 24.
■ Before performing any service or maintenance,
lower attachment to ground, turn off engine, set
parking brake, and remove key.
■ NEVER GO UNDERNEATH EQUIPMENT. Never
place any part of the body underneath equip-
ment or between moveable parts even when the
engine has been turned off. Hydraulic system
leak-down, hydraulic system failures, mechan-
ical failures, or movement of control levers can
cause equipment to drop or rotate unexpectedly
and cause severe injury or death.
•
Service work does not require going under-
neath implement.
•
Read Operator's Manual for service in-
structions or have service performed by a
qualified dealer.
■ Keep all persons and animals away from opera-
tor control area while performing adjustments,
service, or maintenance.
■ Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protec-
tive equipment for eyes, hair, hands, hearing,
and head; and respirator or filter mask where
appropriate.
MAN1378
( 03/07/2024 )
MAN1378_2024-03.indd 15
MAN1378_2024-03.indd 15
ASSEMBLY
before
tightening
hardware.
WARNING
CAUTION
ASSEMBLE GRADING SCRAPER
GSXX.30, GSXX.40 Models
1. Remove frame, loose parts and hardware from
shipping crate.
2. Attach left mast plate (3) to scraper frame (1) using
cap screws (23), washers (24) and nuts (25). See
Figure 8.
3. Repeat step 2 for the right mast plate (2).
4. Locate sleeves (10) between mast plates lower
holes. Secure with cap screws (26), washers (27)
and nuts (28).
5. Torque hardware to recommended values shown on
page 24.
All Models
Early production models do not have scarifiers installed
for shipment. Locate scarifiers in shipping crate.
1. Block up scraper by placing two 6" x 6" (15.24 cm x
15.24 cm) blocks under each side frame (see Figure
6).
2. Lower scraper to rest securely on the blocks.
NOTE: Do not block the scraper any higher than
necessary to install the scarifiers.
3. Remove safety pin and bent pin from scarifier
mount. (Figure 7)
4. Install scarifier in the desired hole. Retain with bent
pin and safety pin.
5. Repeat for remaining scarifiers.
Assembly 15
3/7/24 8:58 AM
3/7/24 8:58 AM
Advertisement
Table of Contents
