Table of Contents
Advertisement
REPLACING CUTTING EDGE
All grading scraper models use two 1/2" x 6" (12.7 x
152 mm) cutting edges. They are interchangeable and
reversible.
To service the grading scraper when attached to the
tractor, it must be blocked up off the ground.
1. Place two 6" x 6" (15 x 15 cm) blocks under each
side-frame of the grading scraper (see Figure 6).
2. Lower the grading scraper to rest securely on the
blocks.
NOTE: Do not block the machine any higher than
necessary to remove the shanks or cutting edge.
3. Refer to parts drawing for your model, pages 20 - 25.
Remove the lock nuts and plow bolts from grading
scraper. Turn cutting edge over and use new edge,
or replace it if both edges have been used.
4. Attach cutting edge to grading scraper and secure
with plow bolts and hex nuts previously removed.
Torque plow bolts to specifications given in Bolt
Torque Chart, page 24.
CLEANING
After Each Use
■ Remove large debris such as clumps of dirt,
grass, crop residue, etc. from machine.
■ Inspect machine and replace worn or damaged
parts.
■ Replace any safety decals that are missing or
not readable.
14 Owner Service
MAN1378_2024-03.indd 14
MAN1378_2024-03.indd 14
Periodically or Before Extended Storage
■ Clean large debris such as clumps of dirt, grass,
crop residue, etc. from machine.
■ Remove the remainder using a low-pressure
water spray.
1. Be careful when spraying near scratched or torn
safety decals or near edges of decals as water
spray can peel decal off surface.
2. Be careful when spraying near chipped or scratched
paint as water spray can lift paint.
3. If a pressure washer is used, follow the advice of the
pressure washer manufacturer.
■ Inspect machine and replace worn or damaged
parts.
■ Sand down scratches and the edges of areas of
missing paint and coat with Woods spray paint
of matching color (purchase from your Woods
dealer).
■ Replace any safety decals that are missing
or not readable (supplied free by your Woods
dealer). See Safety Decals section for location
drawing.
STORAGE
■ Block equipment securely for storage.
■ Keep children, bystanders, and animals away
from the equipment and the storage area.
■ To help prevent injury caused by a falling imple-
ment, always detach on a hard level surface.
■ Do not climb or lean on stored equipment.
MAN1378
( 03/07/2024 )
3/7/24 8:58 AM
3/7/24 8:58 AM
Advertisement
Table of Contents
