Assembly 13; Dealer Set-Up Instructions; Assemble Box Scraper; Install Tailgate On Bsm Models (Optional) - Woods BSS54 Operator's Manual

DEALER SET-UP INSTRUCTIONS

Assembly of this Box Scraper is the responsibility
of the WOODS dealer. It should be delivered to the
owner completely assembled and adjusted for normal
conditions.
Complete the Checklists on page 15 before delivering
the attachment to the customer.
The Box Scraper is shipped partially assembled.
Assembly will be easier if components are aligned and
loosely assembled
Recommended torque values for hardware are located
on page 18.
■ Before performing any service or maintenance,
lower attachment to ground, turn off engine, set
parking brake, and remove key.
■ NEVER GO UNDERNEATH EQUIPMENT. Never
place any part of the body underneath equip-
ment or between moveable parts even when the
engine has been turned off. Hydraulic system
leak-down, hydraulic system failures, mechan-
ical failures, or movement of control levers can
cause equipment to drop or rotate unexpectedly
and cause severe injury or death.
• Service work does not require going under-
neath implement.
• Read Operator's Manual for service in-
structions or have service performed by a
qualified dealer.
■ Keep all persons away from operator control
area while performing adjustments, service, or
maintenance.
■ Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protec-
tive equipment for eyes, hair, hands, hearing,
and head; and respirator or filter mask where
appropriate.

ASSEMBLE BOX SCRAPER

1. Remove the banding, straps and lag bolts that holds
the box scrapers and mast plates to the pallet.
MAN0761
( 06/07/2023 )
MAN0761_2023-06.indd 13 MAN0761_2023-06.indd 13
ASSEMBLY
before tightening hardware.
WARNING
CAUTION
Figure 8. Shipping Configuration - Box Scraper
2. Place right mast plate (2) to the inside of right cross
support bar and secure into position using three hex
flange screws (19) and flange lock nuts (17). See
page 16 for part diagram.
3. Repeat step to install left mast plate (3).
4. Place spacer sleeve (23) between mast plates lower
front hole and secure into position using cap screws
(22) two (one on either side) flat washers (21) and
lock nuts (20). Install second sleeve (23) in lower
rear hole.
5. Tighten 5/8 hardware to 170 lbs-ft and 3/4 hardware
to 297 lbs-ft.
2
23
Figure 9. Spacer Sleeve Installation
DP7
INSTALL TAILGATE ON BSM MODELS
(OPTIONAL)
1. Remove rear cutting edge from box scraper.
2. Place tailgate (5) against rear of box scraper and
align mounting holes.
3. Insert tailgate pins (4) through holes on box scraper
and tailgate. Secure tailgate pin into position using
flat washers (24) and spring pins (15).
4. Attach cutting edge against tailgate and align holes
and secure into position using hardware previously
removed.

Assembly 13

3
20
21
22
21
23
21
20
23
2/8/24 8:57 AM 2/8/24 8:57 AM