Table of Contents
Advertisement
en Steaming
Reheating
The reheat function
can be used to warm up food
that has already been cooked, or bread and pastries
from the day before, without affecting their quality.
Proving dough
Dough proves considerably more quickly using the
dough proving
steam heating type than at room tem-
perature and does not dry out.
Defrosting
Use the defrost function
frozen products gently without affecting the quality.
Added steam
When you cook with added steam, the appliance intro-
duces steam into the cooking compartment at various
intervals. This gives your food a crispy crust and a
shiny surface. Meat stays juicy and tender, and only un-
dergoes a minimum reduction in volume.
You can combine added steam with the following
functions:
¡ Types of heating → Page 14
– 4D hot air
– Top/bottom heating
– Circulated air grilling
– Keeping warm
¡ → "Dishes", Page 22
¡ → "Meat probe", Page 20
Steam jet
You can use the steam jet function to specifically add
intensive steam at various intervals. This makes bread
and bread rolls in particular wonderfully crispy and
gives them a golden colour.
The appliance adds clouds of steam to the cooking
compartment for approx. 3 to 5 minutes. Depending on
the operation, you can activate the steam jet several
times.
You can add the steam jet for the following functions:
¡ Types of heating → Page 14
– 4D hot air
– Top/bottom heating
– Circulated air grilling
¡ → "Meat probe", Page 20
Note: Only use the steam jet when cooking compart-
ment temperatures are above 120 °C.
11.3 Setting the type of steam heating
Note:
Observe the instructions for the types of steam heating:
¡ → "Types of steam heating", Page 17
Requirement: The water tank has been filled. If the wa-
ter tank runs dry during operation, a message appears
on the display. Operation is stopped.
→ "Filling the water tank", Page 17
Press "Steam".
1.
Press the required type of steam heating.
2.
Set the temperature using
3.
ment bar. Or enter the cooking time directly via the
number field
.
Press "Cooking time".
4.
A cooking time must always be set for types of
steam heating.
18
to defrost deep-frozen and
or
, or via the adjust-
To change the preset cooking time, press the relev-
5.
ant time value, e.g. minute display "min" or second
display "s".
a The selected value is marked in blue.
Set the cooking time using
6.
ment bar. Or enter the cooking time directly via the
number field
.
If required, use
to reset the adjustment value.
Press "Apply".
7.
Use
to start the operation.
8.
a The appliance starts to heat and the time counts
down.
a When the time has elapsed, a signal tone sounds. A
message appears on the display confirming that the
operation has finished.
Once the cooking time has elapsed:
9.
If required, you can select other settings and re-
‒
start the operation.
When the food is ready, use
‒
pliance off.
Empty the water tank and dry the cooking compart-
10.
ment.
→ "After using steam operation", Page 19
Changing the type of steam heating
When you change the type of steam heating, the other
settings are also reset.
Press
.
1.
Press
.
2.
Press the required type of steam heating.
3.
Reset the operation and use
4.
Changing the temperature
Once the operation has started, you can change the
temperature at any time.
Press the temperature.
1.
Change the temperature using
2.
justment bar. Or enter the temperature directly via
the number field
.
Press "Apply".
3.
Changing the cooking time
You can change the cooking time at any time.
Press the cooking time.
1.
Change the cooking time using
2.
adjustment bar. Or enter the temperature directly via
the number field
.
3.
Press "Apply".
11.4 Setting added steam
Requirements
¡ Observe the information about the respective operat-
ing mode.
→ "Setting options with steam", Page 17
¡ The water tank has been filled. If the water tank runs
dry during operation, a message appears on the dis-
play. The appliance continues to operate but without
injecting steam into the cooking compartment.
→ "Filling the water tank", Page 17
Press the operating mode that you require.
1.
Select the settings for the operating mode, e.g. type
2.
of heating and temperature.
Press "Added Steam" .
3.
Press the required steam level.
4.
or
, or via the adjust-
to switch the ap-
to start.
or
or via the ad-
or
, or via the
Advertisement
Table of Contents
