Table of Contents
Advertisement
WARNING ‒ Risk of fire!
It is dangerous to use an extended power
cord and non-approved adapters.
▶ Do not use extension cables or multiple
socket strips.
▶ Only use adapters and power cords ap-
proved by the manufacturer.
▶ If the power cord is too short and a longer
one is not available, please contact an
electrician to have the domestic installation
adapted.
21.3 Fitted units
This appliance is only intended to be fully fitted in a kit-
chen. This appliance is not intended to be used as a
tabletop appliance or within a cupboard.
The installation cabinet must not have a back panel be-
hind the appliance. The minimum installation height is
850 mm.
Ventilation slots and intakes must not be covered.
The appliance must be securely fitted once it is in-
stalled and must not tip over.
21.4 Electrical connection
In order to safely connect the appliance to the elec-
trical system, follow these instructions.
¡ The appliance corresponds to protection class I and
must only be operated with a protective earth con-
nection.
¡ The fuse protection must correspond to the power
rating specified on the appliance's rating plate and
to the local regulations.
¡ The appliance must be disconnected from the
power supply whenever installation work is being
carried out.
¡ The appliance must only be connected using the
power cable provided.
¡ The power cable must be plugged in at the rear of
the appliance. A 5 m power cable can be obtained
from customer service.
¡ The power cable must only be replaced with a cable
from the original manufacturer. This is available from
customer service.
Connecting the appliance to the electricity
supply
Note: The appliance must only be connected to a pro-
tective contact socket that has been correctly installed.
Insert the non-heating appliance plug of the power
1.
cable into the appliance.
Check that the non-heating appliance plug is inser-
ted properly.
Insert the mains plug of the appliance into a nearby
2.
socket.
When the appliance is installed, the mains plug of
the power cable must be freely accessible. If free
access to the mains plug is impossible, an all-pole
isolating switch must be integrated into the perman-
ent electrical installation in accordance with the in-
stallation regulations.
21.5 Installation in an upper cabinet
Observe the installation dimensions and the safety
clearances in a tall unit.
Do not fit the appliance too high up; it must be pos-
sible for accessories to be removed easily.
Remove the feet.
21.6 Installation in a tall unit
Observe the installation dimensions and the safety
clearances in a tall unit.
Do not fit the appliance too high up; it must be pos-
sible for accessories to be removed easily.
Installation instructions en
29
Advertisement
Table of Contents
