Dimensional Drawings - United Electric Controls VANGUARD Installation And Operation Instruction Manual
Wirelesshart toxic & combustible gas detector
Hide thumbs
Also See for VANGUARD:
Table of Contents
Advertisement
Possible issues during the connection process are highlighted in Table 12 below:
SYMPTOM
Battery is not connected properly Check that the battery is connected correctly. See Section 2.1 on battery installation.
Incorrect Network ID and Join Key Check the Network ID and Join Key
Network is not self advertising
Device is not joining
Insufficient routing nodes
the network
Network is oversubscribed with
Excessive network
rejoins
Unreliable routing nodes
6.0 DIMENSIONAL DRAWINGS
2.9 in
(73 mm)
2.9 in
(73 mm)
4X
[10mm]
Ø 0.4 in
POSSIBLE CAUSES
Check that the network is in the active network advertise mode
Check that the device is within the range of at least one other device in the mesh
network. Add more wireless points
Check that the maximum devices on the network has not been exceeded
Wait for at least 15 minutes after the start up
devices
Power cycle device and try again
Send the device back to factory
Antenna issue
Check antenna signal strength on asset management system
Relocate device so it has multiple communication paths or add another node in
between
6.9 in
(176 mm)
3.6 in
(91 mm)
TCD 60 shown with Standard Mount
Models
Antenna
TCD50
1
2
TCD60
3
4
RECOMMENDED ACTION
L
Gain (dBi)
L
2
12.4" (315 mm)
2
16.2" (412 mm)
4.35
16.6" (422 mm)
6
18.9" (482 mm)
17
Table 12
8.7 in
(221 mm)
IM_TCD60 02
Advertisement
Table of Contents
