United Electric Controls VANGUARD Installation And Operation Instruction Manual page 14

3.3.5 HART Command 129 Write
Calibration Point
Request bytes:
Bytes Format Description
0-3 Float Concentration of gas used during calibration
Response bytes:
Bytes Format Description
0-3 Float Concentration of gas used during calibration
Command Specific Response Code:
Code Class Description
0 Success No command specific errors
2 Error Concentration too low
3 Error Concentration too high
4 Error Concentration not valid
5 Error Incorrect number of data bytes received
3.3.6 HART Command 131 Read Sensor
Activation State
Request bytes:
Bytes Format Description
None
Response bytes:
Bytes Format Description
0-1 Unsigned-16 Sensor type (0=Not Activated)
Command Specific Response Code:
Code Class Description
0 Success No command specific errors
3.3.7 HART Command 132 Read Base Unit
Configuration String
Request bytes:
Bytes Format Description
None
Response bytes:
Bytes Format Description
Unit Configuration String, (e.g., UEC100 SW
0-39 Latin-1
2.20 HW 1.21)
Command Specific Response Code:
Code Class Description
0 Success No command specific errors
3.3.8 HART Command 133 Read Sensor
Module Configuration String
Request bytes:
Bytes Format
None
Response bytes:
Bytes Format
0-39 Latin-1
Command Specific Response Code:
Code Class
0 Success
3.3.9 HART Command 138 Read Sensor
Type String
Table 6
Request bytes:
Bytes Format
0 Unsigned 8
Response bytes:
Bytes Format
0 Unsigned 8
1-16 ISO-Latin1
Command Specific Response Code:
Code Class
0 Success
1 Error
2 Error
Table 7
Table 8
14
Description
Description
Sensor Module Configuration String (e.g.,
H2S: 02031 08035278 02 MIPEX-2_25.6)
Description
No command specific errors
Description
Device Variable Code
Description
Device Variable Code
Variable Type String
Description
No command specific errors
Wrong Number of Data Bytes
Invalid Selection
IM_TCD60 02
Table 9
Table 10