Tricity Bendix 1568 Operating Instructions Manual page 9

REVERSIBLE MAIN OVEN DOOR _ 7. Fit the two hinge brackets supplied to
© ee eG eae ea ~*C«~' the right hand side. The bracket with
the hinge pin goes to the top right-hand
side of the cooker. (G).
8. Lift out door stay securing pin and
locate it in opposite lower hinge
bracket. (B).
9. Remove the top and bottom left-hand
hinge brackets.
10. Before refitting the door, remove the
door catch striker and plate from the
right-hand side of chassis, and remove
blanking screw from the left-hand side
of the chassis, and interchange their
positions, do not fully tighten the
striker at this stage. (D).
11. Torefit the door, engage the top of the
door onto the upper right-hand hinge
pin, and secure the bottom by screwing
in the lower hinge pin through the
right-hand lower hinge bracket. (C).
12. Engage door stay with door stay
securing pin on right hand lower hinge
Tools required are one crosshead
(pozidrive) screwdriver and one small
adjustable spanner.
The main oven door of the cooker can be
changed from left to right-hand hinging,
if required. This is a reasonably simple
operation if carried out in accordance with
these instructions.
i ea bracket, make sure that the washer is
{Cr : placed between door stay arm and clip,
slide clip into place over door stay
1. Open main oven door. securing pin. Again, a mirror may help
2. Remove main oven door stay by sliding during this process. (A).
the clip off the door stay securing pin 13. Final adjustment:— to ensure door
on lower hinge bracket. (If this seems closes correctly, slowly close the door
difficult a mirror may be laid on the to centralise the catch, carefully open
floor immediately below the lower the door and tighten the catch.
hinge bracket.) (A). 14. Open door to check operation.
3. Using a small adjustable spanner,
remove lower hinge pin while
supporting oven door. (C).
. Remove door.
. Invert the door and remove the spring
clip washer and door stay from the
slider pin. Reposition the door stay
washer and clip on the other slider pin.
(E).
6. Remove left hand blank plate and
latch. Transfer blank plate from right
hand to left hand side. Fit latch and
blank plate to right hand side of door.
The door latch can now be fitted to the
left-hand side of the door. (F).
na
This appliance complies with the
Radio Interference requirements of
EEC Directive 82/499/EEC.