Use Burners - Electrolux UltimateTaste 300 Manual

1) BURNERS
A diagram is screen-printed above each knob on
the front panel. This diagram indicates to which
burner the knob in question corresponds. After
having opened the gas mains or gas bottle tap,
light the burners as described below:
- Automatic electrical ignition
Push and turn the knob corresponding to the
required burner in an anticlockwise direction until it
reaches the full on position (large flame fig. 1),
then depress the knob.
- Lighting burners equipped with flame failure
device
The knobs of burners equipped with flame failure
device must be turned in an anticlockwise direction
until they reach the full on position (large flame fig.
1) and come to a stop. Now depress the knob in
question and repeat the previously indicated
operations.
Keep the knob depressed for about 10 seconds
once the burner has ignited.
HOW TO USE THE BURNERS
Bear in mind the following indications in order to
achieve maximum efficiency with the least possible
gas consumption:
- use adequate pans for each burner (consult the
following table and fig. 2).
- When the pan comes to the boil, set the knob to
the reduced rate position (small flame fig. 1).
- Always place a lid on the pans.
- Use only pan with a flat bottom.
Full on
position
Closed position
Reduced rate
position
FIG. 1
USE
Burners
Ultra rapid
Rapid
Semirapid
Auxiliary
WARNINGS:
- burners with flame failure device may only be
ignited when the relative knob has been set to
the Full on position (large flame fig. 1).
- Matches can be used to ignite the burners in
a blackout.
- Never leave the appliance unattended when
the burners are being used. Make sure there
are no children in the near vicinity.
Particularly make sure that the pan handles
are correctly positioned and keep a chek on
foods requiring oil and grease to cook since
these products can easily catch fire.
- Never use aerosols near the appliance when it
is operating.
- Containers wider than the unit are not
recommended.
5
Pan Ø
in cm
24 ÷ 26
20 ÷ 22
16 ÷ 18
10 ÷ 14
FIG. 2