Electrolux UltimateTaste 300 Manual page 9

4) FIXING THE HOT PLATE
The hot plate has a special seal which prevents
liquid from infiltrating into the cabinet. Strictly
comply with the following instructions in order to
correctly apply this seal:
- detach the seals from their backing, checking
that the transparent protection still adheres to the
seal itself.
- Overturn the hot plate and correctly position seal
"E" (fig. 10) under the edge of the hot plate itself,
so that the outer side of the seal perfectly
matches the outer perimetral edge of the hot
plate. The ends of the strips must fit together
without overlapping.
- Evenly and securely fix the seal to the hot plate,
pressing into place with the fingers and remove
FIG. 10
INSTALLATION
FIG.13
the strip of protective paper from the seal and set
the plate into the hole made in the cabinet.
- Carefully trim the edge excess putty with a tool
(fig. 11 - 12).
- Fix the hob with the proper brackets "S" and fit
the prominent part into the porthole "H" on the
bottom; turn the screw "F" until the bracket "S"
stick on the top (fig. 13).
- In order to avoid accidental touch with the
overheating bottom of the hob, during the
working, is necessary to put a wooden insert,
fixed by screws, at a minimum distance of 70
mm from the top (see fig. 9).
FIG. 11
9
FIG. 12