Table of Contents
Advertisement
RS485 Configuration Setup for ULP (just wind meter, NO HEATING)
The ULP SUMMIT HEATED can be set up by using a special configuration app made by
Calypso Instruments. In order to use the app, you should download the configurator from our
website at www.calypsoinstruments.com.
For more information, please watch the following video.
https://bit.ly/3DuA7lM
*USB converter cables available on calypsoinstruments.com.
This are the STEPS to FOLLOW to Configurate your DEVICE Successfully:
1. Use a USB to RS485 Converter cable to connect your wind sensor to your computer.
2. Connect all the cables to the USB converter cable EXCEPT for the BROWN cable.
3. Open the Configurator app, select your COM port and Click on "Connect button"
4. Connect the brown cable when the configurator tells you to.
5. Wait a few seconds and Configure your Anemometer. In this case, select "Stream" and
configure your anemometer. When you've finished the configuration click on "Start Configu-
ration" ("SAVE Configuration" in the image)
ULP SUMMIT HEATED User Manual
7
Advertisement
Table of Contents
Need help?
Do you have a question about the ULTRA-LOW-POWER ULTRASONIC SUMMIT HEATED and is the answer not in the manual?
Questions and answers