Appearance - TP-Link DS-P7500-08 Installation Manual

DeltaStream 8-port Pizzabox XGS-PON&GPON Combo Optical Line Terminal
1.2

Appearance

Front Panel
■
The front panel of DS-P7500-08
purposes only. Your device may differ in appearance from the depicted.
PON
PON
The PON port connects to the XGS-PON&GPON network via an OLT SFP module and an optical cable.
XGS-PON&GPON networks are extended from the PON ports of OLT, and oriented to the locations of
ISP's end users.
QSFP+
The QSFP+ port connects to the uplink network of ISP's central office via an 40 Gbps SFP+ module and
an optical cable.
SFP+
The SFP+ port connects to the uplink network of ISP's central office via an 10 Gbps SFP+ module and an
optical cable.
MGMT
The MGMT port connects to a management terminal like a PC via an Ethernet cable, and then the
network manager can configure and monitor the device via the management webpage.
Console
The Console port connects to a management terminal like a PC via an RJ45 console cable, and then the
network manager can configure and monitor the device via the CLI (Command Line Interface).
Alarm
The Alarm port connects to a monitoring device, sending alarm messages.
Reset
If you want to reset the the device, press and hold the reset button for more than 5 seconds.
LEDs
LED Indication
On: The device is powered on.
PWR Off: The device is powered off or power supply is abnormal.
Flashing: Power supply is abnormal.
is shown as the following figure. The figure is for demonstration
QSFP+ SFP+ MGMT Console Alarm Reset LEDs
Introduction 3