Installing The Latch Rod - Toro 79501 Operator's Manual

6. Install the bent, flared end of a rod into the
keyed slot in the side of the machine frame, and
move the rod rearward to seat it in the frame
(Figure 9).
Note:
Repeat this step for both sides of the
machine.
7. With the rod fully seated in the frame, adjust
the position of the clevis at the end of the rod
so that it aligns with the tab on the side of the
bagger frame.
Note:
Ensure that the rod is taught and holds
the bagger frame securely to the machine;
adjust the clevis as necessary.
Figure 9
Left side shown
1. Rod fully seated in the
frame
8. Secure the ends of the rods to the bagger frame
as shown in Figure 9
rod with a clevis pin and a hairpin.
2. Clevis adjusted to the side
of the bagger frame
and secure the end of each
4

Installing the Latch Rod

Parts needed for this procedure:
1 Latch rod
1 Hairpin cotter
Procedure
Install the latch rod with a hairpin cotter
1. Hairpin cotter
g462501
2. Latch rod
9
(Figure
Figure 10
3. Latch rod hole (60 inch
decks)
4. Latch rod hole (50 and 54
inch decks)
10).
g467364