Table of Contents
Advertisement
Ericsson | Antenna Line Configurator
3 Prerequisites
• Make sure that the Remote Control Unit (RCUs) and ALDs that are configured with the ALC
are correctly installed and connected to the AISG bus�
• Make sure that each RCU is calibrated before the initial configuration of the inclination
angle, after each manual adjustment to the inclination angle, and each time the RCU is
removed�
If the above instructions are not followed, this can result in an imprecise configuration of the
inclination angle�
• Correct calibration requires that the RCU is installed at the provided antenna interface�
• Make sure that the USB stick has ≥ 512 MB of storage space.
Note
ALCs with the new Ericsson display only work with firmware version 3.5 or higher.
9
Advertisement
Table of Contents
