9�4 Operate The Ericsson Flexret - Ericsson 86010158 Manual

Antenna line configurator (alc)

Table of Contents

Ericsson | Antenna Line Configurator

9�4 Operate the Ericsson FlexRET

Antennas with Ericsson FlexRET are factory-installed

with a Radio Frequency Identification (RFID) tag� The

tag contains key configuration data for the antenna� The

configuration details exported by the FlexRET and is read

by the ALC when scanning the AISG bus when connected to

a FlexRET�

Fig� 54: Devices: Connected to a FlexRET

① Opens the list with the individual subunits, see section

9�4�2

② Opens the FlexRET properties, see section 9�4�1

③ Generates ALD reports, see section 9�3

④ Selects the AISG protocol scanning options, see

section 9�1�1

Prerequisites:

• The ALC has found the ALD�

• The ALD is connected to the ALC, see section 9�1 and 9�2

1� Tap ① in Fig� 54 to open the list with the individual

subunits� The following page is shown:

Fig� 55: Devices: Configuring the individual

FlexRET subunits

① Shows the list of the individual subunits

② Opens the properties of the selected subunit, see

section 9�4�2

③ Opens the FlexRET properties, see section 9�4�1

④ Generates ALD reports, see section 9�3

⑤ Selects the AISG protocol scanning options, see

section 9�1�1

Table of Contents