Advertisement
Fault finding
5.1 THE BEATER WILL NOT START
• Check that :
- The beater is plugged in.
- The electrical power supply to the socket is correct.
- The bowl is in position on the cradle.
- The safety guard is duly lowered.
• If the appliance does not restart:
- Unplug the appliance and reconnect it after a few seconds.
• If the beater stops in mid cycle:
5.2 ABNORMAL NOISE OR OPERATION
a) Metallic noise
- Distorted tool that is rubbing.
- Bowl damaged, not in place (See
b) The tool is not or insufficiently driven but the motor is
running, check:
5.3 BLOCKING OF A TOOL ON THE TOOL-HOLDER SPINDLE
• Generally due to poor cleaning or a distorted tool caused by a
shock.
• If the tool begins to block, do not force it. Apply some oil or
release fluid and wait for a few minutes until the product works.
• Work it progressively, applying efforts:
- Rotationally in a back and forth motion.
- By tapping the tool with a mallet, after clearing the pin from the
Maintenance
6.1 MECHANICAL PARTS
• The beater requires only a minimum amount of maintenance
(the bearings, motor and mechanical parts are greased for life).
• You are advised to check the tension and wear of the belt at
least once a year.
In order to check it, proceed as follows:
- Disconnect the beater from the mains.
- Take down the top cover (rear screws + front tab)
ATTENTION: do not force on the tab when dismant-
ling. Just rotate the appliance forwards slightly to
release the cover.
6.2 VERIFICATION OF THE SAFETY DEVICES
• Frequent checks for the correct operation of the safety devices
should be made. The motor should stop when the distance
between the guard and the bowl exceeds 8mm on opening
the guard.
6.
The machine must not operate if the bowl is
not in position on the cradle.
6.3 ELECTRICAL COMPONENTS
• Check the condition of the power cable and the electrical com-
ponents regularly.
§ 3 and § 4).
2
- The temperature probe of the motor has been triggered or
the electronic system has detected an overload. Wait an extra
few minutes in the event of overheating before starting back up.
Reduce the load in the bowl and disconnect the appliance for
at least one minute before reinitialising. Put the speed variation
button back to zero before starting back up.
If the problem persists, contact the service department
of your local dealer.
- the tension and wear of the belt (See
- The connection between the motor and variable speed drive.
If the problem persists, contact the service department
of your local dealer.
bayonet.
-
Using fine abrasive paper, smooth off the deformed part if
necessary.
If the problem persists, contact the service department
of your local dealer.
- If the belt needs retightening, unscrew the 3 fixing screws from
the motor in order to move it.
Note: the notched belt should be moderately tightened.
- If the belt requires changing, the speed reader must first
be cleared, then slide the belt outside the driven pulley, then
remove it from the drive pulley without changing the position
of the motor.
- Check the electrical connections, clean and reassemble in
reverse order.
• If this is not the case:
- Do not use the machine.
- Have it adjusted by the service department of your local dealer.
5
§ 6.1).
Electromix 5 GB 11 2023
Advertisement
