Audi A3 2016 Owner's Manual page 122

e-tron
Charging times
Applies to vehicles: with plug-in hybrid drive
The length of the charg ing process using the Audi
e-tron charging system can vary based on the fol-
lowing factors:
- Sockets be ing used (household or industrial
sockets).
- System voltage and current strength specific to
a country.
- The value set for the charg ing power level on
the control unit (SO% or 100%) .
- Fluctuations in the system voltage .
- Temperature outside the vehicle.
- Temperature of the high-voltage battery .
- Adjustments to the climate control inside the
vehicle.
- Current capacity of the charging connector.
Examples of charging times
Connection Charging time for
100% charge
Household socket approximately 10
(100 V, 10 A)
hours
Household socket approximately 8 .2
(110 V, 10 A) hours
Household socket
approximately 5.2
(220 V, 8 A)
hours
Household socket app roximately 3 .8
(230 V, 10 A)
hours
Industrial socket (200 V, approximately 2 .3
16 A) hours
Industrial socket (220 V, approximately 2 .3
16 A) hours
Industrial socket (230 V, approximately 2 .3
16 A)
hours
Industrial socket (240 V, approximately 2.3
16 A) hours
(D
Tips
- Multiple versions of charging cables are of-
fered due to the different power supply sys-
tems in different countries. The maximum
charging power may potentially be unavaila-
ble because of this. Contact an author ized
120
Audi dealer or authorized Audi Service Fa-
cility for more information.
- The charging times may be longer in ex-
tremely high or low temperatures .
Audi e-tron charging system PIN
Applies to vehicles: with plug-in hybrid drive
The control unit can be locked by entering a 4 -
digit PIN of your choice. If a PIN is activated, the
selected PIN must be entered before every use.
We recommend locking your control unit to pro-
tect it aga inst unauthorized access by a third par-
ty.
Activating the PIN
.. Press the I OK!@ ¢
page
115,
fig.
106 button
on the control unit. POWER and SET PIN ap-
pear in the disp lay fie ld .
.. Select SET PIN using the arrow button © -
.. Press the IOKI button @ . ENTER PIN appears in
the display field .
.. Select the desired value by pressing the arrow
buttons © up or down .
.. Use the right arrow button © to go to the next
dig it.
.. Press the left arrow button © to go to the pre-
vious menu.
.. Enter all of the digits.
.. Press the IOKI button @ after the last digit.
.. REPEAT PIN appears on the display field .
.. Enter the PIN again using the arrow buttons
©-
.. Press thelOK l@ button .
.. PIN OK appears in the display field if both en-
tries match .
.. The PIN is now activated.
Deactivating the PIN
Requirement: the control unit must be unlocked.
.. Enter the numerical code
0000.
Proceed as if
you were activating the PIN ¢
page
120.
.. The PIN is deactivated.
Locking the control unit
Requirement: the PIN must be activated.