Page 5
ASSEMBLY INSTRUCTIONS 2pcs 2pcs 2pcs 2pcs 4pcs 32pcs 112pcs When connecting B and B1 via P,C and C1 via P, make sure that 1 holes on part P (as shown in the picture) should be facing upwards. Do not install it upside down.
Page 16
ASSEMBLY INSTRUCTIONS 4pcs 4pcs 2pcs Before installing Parts R1/R2/R3, remove protective films (with side marks) on both the front and back sides. After removal, there will be no mark and minimal difference between the sides. Therefore, pay close attention to directions before removal.
Page 18
ASSEMBLY INSTRUCTIONS 2pcs 4pcs 4pcs 2pcs 4pcs 4pcs Before installing Parts Q/Q1/Q2, remove protective films (with side marks) on both the front and back sides. After removal, there will be no mark and minimal difference between the sides. Therefore, pay close attention to directions before removal.
Page 19
ASSEMBLY INSTRUCTIONS 2pcs 4pcs 4pcs 4pcs 4pcs 4pcs 4pcs Before installing Parts Q/Q3/Q4, Q5/Q6remove protective films (with side marks) on both the front and back sides. After removal, there will be no mark and minimal difference between the sides. Therefore, pay close attention to directions before removal.
Page 21
ASSEMBLY INSTRUCTIONS 4pcs Pay attention to the sidewall curtain's installation position.
Page 22
ASSEMBLY INSTRUCTIONS 4pcs Note: Attach 1 to 2 to secure parts S (netting) and T (curtains) together. Attach 1 to 3 to secure the back curtain (T). Attach 1 to 3 to secure the front netting (S). Pay attention to the sidewall Hang the hook attached to netting's installation position.
Page 23
ASSEMBLY INSTRUCTIONS 12pcs Installation Completed Cement surfaces To improve wind resistance, Expansion screws are essential for be sure to complete this installation stability on cement surfaces, step. If expansion screws or ground All are included in the accessories nails are not installed,strong winds package.