Display & Indicators; Acceptable Carbon Monoxide Levels; Blade Assembly - Bartell Global T-5500 PRO Owner's Manual

Ride-on terminators

Table of Contents

RIDE-ON SCRAPER

OWNER'S MANUAL AND

PARTS BOOK

To increase tension on the brake you can rotate the end of the handle in a clockwise

direction. Rotate the end of the handle counterclockwise to reduce the tension.

1. Tachometer & Information Display

The tachometer shows the current RPM. The information display shows the instantaneous

readings of selected engine sensors and can also show any active error codes from the

engine control unit (ECU).

2. Malfunction Indicator Light

The Malfunction Indicator Light (MIL) will illuminate when the engine is running out of

specification. The illumination of the MIL will typically be accompanied by an error code,

which can be accessed and displayed on the information display.

3. Hydraulic Filter Clog Indicator

The hydraulic oil filter is equipped with a clog indicator which will illuminate when the

hydraulic oil filter is clogged. The indicator may briefly illuminate in cases of extreme cold

and will turn off when the hydraulic oil was warmed to a normal operating temperature.

IMPORTANT! OSHA Requirement – What Service Personnel Should Know!

The CO level shall not exceed 35 parts per million (PPM) measured over an 8-hour period in

the work environment. 1,000,000 PPM is equivalent to 100% of all exhaust gases. For each

one one-hundredth of one percent, you will have 100 PPM.

With adequate ventilation and following the enclosed adjustment instructions, you should be

able to keep the CO level below the OSHA requirement. Innovatech strongly recommends the

use of a CO analyzer.

Blades are available in different configurations and thickness. An assortment of blades is

included in the purchase price of the Terminator

Innovatech Products & Equipment Co., Inc.

Installing a Blade:

Raise the jaw assembly to maximum up position.

Unwrap the pre-sharpened blades and select the blade thickness and length you need for

the job.

14. Display & Indicators

. Extra blades are available upon request from

OIPB-I12030

Table of Contents