General Operating Instructions For The Terminator; Safety Features; O 1. Auto Stop; O 3. Fire Extinguisher - Bartell Global T-5500 PRO Owner's Manual

RIDE-ON SCRAPER
OWNER'S MANUAL AND
PARTS BOOK

4. General Operating Instructions for the Terminator

®
The Terminator is designed to remove carpet, tile, and glue residue from floors.
• When removing product, position removed product, so it rolls to the side of the machine or
have someone on the side of the machine remove the product. NEVER WALK IN FRONT OF
OR BEHIND THE TERMINATOR
• Sharpen blades or dice material into narrower widths if machine slows down or seems to be
struggling.
• Do not use the Terminator
may occur if the Terminator
• Use safe, OSHA-approved tools and methods for sharpening blades.
• Make sure the Terminator
light before operating.
The Terminator ® is equipped with several features to help ensure your safety and the safety of
workers around you.
1. Auto Stop
®
The Terminator
jaw height lever to the left of the operator seat. The drive levers control the forward, reverse,
left, and right directions of the machine; the jaw height lever raises and lowers the jaw
assembly. You must push (forward) or pull (reverse) and hold the levers in position to drive
the machine or move the jaw assembly in the direction desired. When you release a lever,
®
the Terminator or jaw automatically STOPS and will not move again until you push/pull and
hold the levers again. However, these levers are not meant as brakes. Block wheels with a
floor block when stopping on a ramp and use the emergency brake. Without the emergency
brake the machine may roll forward or backwards on any sloping surface.
2. Warning Light and Back-Up Alarm
An amber light is installed on the top section of the rear battery box. When the ignition is in
the ON position, the warning light will flash. When the drive control is set in REVERSE, the
back-up alarm will sound.
3. Fire Extinguisher
A fire extinguisher with gauge is installed on the hood behind the operator's seat within the
operator's reach. As a safety measure, regularly inspect the gauge and recharge the fire
extinguisher as needed to maintain full capacity. Always recharge the extinguisher after
each use.
4. Emergency Battery Disconnect
Under the hood at the front of the engine is a battery disconnect that will remove power from
the motor and other electrical components. WARNING: Removing power from the
®
WHILE IT IS RUNNING.
®
within one foot of walls or stationary objects. Damage to objects
®
strikes them.
®
has a charged fire extinguisher, working backup alarm, and strobe

5. Safety Features

has two drive levers located to the right and left of the operator seat and a
9
OIPB-I12030
®