Loading/Unloading Procedures; Operator Controls; O 1. Drive /Jaw Controls; O 2. Auto Stop - Bartell Global T-5500 PRO Owner's Manual

RIDE-ON SCRAPER
OWNER'S MANUAL AND
PARTS BOOK
• Do not load or unload the Terminator
• Ensure ramps into moving vehicles are stable and square to the ground.
• Always turn off the Terminator
• Load and unload the machine with a properly weighted forklift or lift-gate.
• Make sure all safety stops are installed on a lift-gate before loading or unloading.
• Never position yourself under/around the machine while moving it with other machinery.
• Park the machine with the jaw completely down after loading.
• Properly secure the machine with chains, tire chocks, and other necessary tie downs.
• Never ride in a moving vehicle next to a Terminator
1. Drive/Jaw Controls
The drive and jaw controls are located to the left and right of the operator seat. The drive
joysticks (left and right) control the direction of rotation of the rear wheels. The jaw height
rocker module (right) controls the vertical position of the jaw assembly. The throttle slider
module (left) controls the RPM of the engine.
 Push the left and right joysticks forward together and hold them in position to move the
machine forward.
 Pull the left and right joysticks back together and hold them in position to move the
machine in reverse - the alarm will sound.
 Push only the left joystick forward to turn the machine to the right.
 Push only the right joystick forward to turn the machine to the left.
 To move the jaw assembly down, push and hold the jaw rocker upward. To move the jaw
assembly up, push and hold the jaw rocker downward.
2. Auto Stop
When you release the drive joysticks, the motor continues to run but the drive or jaw motion
automatically stops and will not start again until you push or pull the joysticks.
3. Operator Presence Switch & Safety Grips
®
The Terminator
operator must also be seated to engage the operator presence switch within the seat. The
wheel hydraulics will not function without an operator properly seated and at least one
trigger switch held down. WARNING: The Terminator
switches are released or if the operator leaves the seat while the machine is moving.
4. Emergency Brake
®
The Terminator
when left unattended. The brake handle is located to the right of the operator seat. Pull the
handle up to engage the brake, push the handle down to release the brake.

12. Loading/Unloading Procedures

®
on uneven ground.
®
before transporting it.

13. Operator Controls

is equipped with a trigger switch on the underside of each joystick grip. The
is supplied with an emergency brake to prevent unintended movement
® . It may tip, causing severe injury.
®
will stop abruptly if both trigger
13
OIPB-I12030