Table of Contents
Advertisement
RIDE-ON SCRAPER
OWNER'S MANUAL AND
PARTS BOOK
11. Uncrating and Preparing the Terminator
When you receive the Terminator
damage to the crate itself. If it is damaged, notify the carrier immediately and follow his/her
instructions to file a claim.
Carefully uncrate the machine and inspect it for damage that may have occurred during
shipping. If the shipment is damaged, notify the carrier immediately and file a claim in the
normal manner.
Check packing slip for complete shipment. If shipment is incomplete, notify our Customer
Service Department within 24 hours.
Remove the crate debris, set aside the blades and other packages, and prepare the
Terminator
®
for operation:
CAUTION! If using conventional non-AGM lead acid batteries, wear acid-resistant gloves and
safety glasses and use extreme care when checking battery water levels.
1. To remove the Terminator
1. Forklift slots have been provided on the sides of the Terminator
terminator with a forklift.
2. To remove the Terminator
1. Turn the Battery Disconnect to the "On" position.
2. Take 2 x 4's off the edge of the crate and between the wheels.
3. Place 2 x 4's behind the crate of the rear of the machine.
4. Make a ramp with the 2 x 4's and the crate material.
5. To start the Terminator
6. Raise the front wheel 5 inches by using the jaw adjustment slider on the joystick.
7. Pull back both joysticks evenly. The machine will start moving slowly.
8. Ensure that both rear wheels come off the crate evenly. Failure to back off evenly could
result in the machine tipping over and harm to the operator.
9. As the machine moves back, ensure that the center wheel clears the crate. If the center
wheel does not clear the crate, raise the machine until the wheel clears.
10. Once the machine is on the ramp, slide it all the way to the bottom, then raise the jaw
assembly up and set the center wheel down on the ground.
®
, inspect the outside of the crate completely, to detect
®
from a crate with a forklift:
®
from a crate without a forklift:
®
, turn the key.
12
OIPB-I12030
®
for Operation
®
for moving the
Advertisement
Table of Contents
