Table of Contents
Advertisement
Quick Links
Gebrauchs- und Montageanleitung
Instructions for installation and use
Instructions de montage et d'emploi
Wichtig: Unbedingt lesen und aufbewahren!
Important: Read these instructions carefully and then store them in a safe place
Important: Lire attentivement et ranger soigneusemnt ce mode d'emploi
Integrierte Kühl-Gefriergerät
Integrated Fridge -Freezers
Réfrigérateur - Congélateurs à intégrer
Modell: IKE 257-7-2T
F
GB
p.: 13-22
23-33
2223 155-13
Advertisement
Table of Contents
Related Manuals for Kuppersbusch IKE 257-7-2T
Summary of Contents for Kuppersbusch IKE 257-7-2T
- Page 1 Important: Read these instructions carefully and then store them in a safe place Important: Lire attentivement et ranger soigneusemnt ce mode d’emploi Integrierte Kühl-Gefriergerät Integrated Fridge -Freezers Réfrigérateur - Congélateurs à intégrer Modell: IKE 257-7-2T p.: 13-22 23-33 2223 155-13...
-
Page 2: General Safety
WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. -
Page 3: Environment Protection
• Do not place carbonated or fizzy drinks in the connecting the appliance to allow tl¦e oil to flow freezer as it creates pressure on the container, back in the compressor. which may cause it to explode, resulting in damage to the appliance. Environment Protection Installation This appliance does not contain gasses which... - Page 4 Temperature regulation Storage of frozen food The temperature is automatically regulated and can When first starting-up or after a period out of use, be increased to achieve a higher temperature before putting the products in the compartment let (warmer) by rotating the thermostat knob toward the appliance run for at least two hours on the lower settings or reduced (colder) rotating the knob coldest setting, then turn the thermostat knob to the...
- Page 5 Movable shelves The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. D338 Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be placed at different heights. To make these adjustments proceed as follows: Gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required.
-
Page 6: Maintenance
1 - 2 3 - 4 3 - 6 3 - 6 3 - 6 3 - 6 10 -12 10 -12 10 -12 10 -12 MAINTENANCE Periods of non-operation Unplug the appliance before carrying out When the appliance is not in use for long periods, any maintenance operation. -
Page 7: Customer Service And Spare Parts
The freezer compartment, however, will become progressively covered with frost. This should be Important: removed with a plastic scraper, whenever the Never use sharp metal tools to scrape off frost thickness of the frost exceeds 4 mm. During this from the evaporator as you could damage it. operation it is not necessary to switch off the power supply or to remove the foodstuffs. - Page 8 The Manufacturer declines all responsibility if ATTENTION! the above safety precautions are not observed. It must be possible to disconnect the appliance from This appliance complies with the following the mains power supply; the plug must therefore be E.E.C. Directives: easily accessible after installation.
- Page 9 It is necessary that the niche is provided with a conduct of ventilation having the following dimensions: Depth 50 mm Width 540 mm Make sure that a distance of 44 mm is maintained in PR01 the lower part between the kitchen furniture and the border of the appliance.
- Page 10 Apply covers (C-D) on joint cover lugs and into hinge holes. Snap vent grille (B) and hinge covers (E) into position. Separate parts Ha, Hb, Hc, Hd as shown in the figure PR266 Place guide (Ha) on the inside part of the furniture ca.
- Page 11 Remove the brackets and mark a distance of 8 mm from the outer edge of the door where the nail must be fitted (K). Place the small square on the guide again and fix it with the screws supplied. Should the lining up of the furniture door be necessary, use the clearance of slots.
- Page 12 KÜPPERSBUSCH HAUSGERÄTE AG Postfach 10 01 32, D-45801 Gelsenkirchen, Küppersbuschstr. 16, D-45883 Gelsenkirchen Telefon: (02 09) 4 01-0, Telefax: (02 09) 4 01-3 03 www.kueppersbusch.de Küppersbusch Ges. m. b. H. Eitnergasse 13, 1231 Wien, Telefon: 01 / 8 66 80-0, Telefax: 01 / 8 66 80 72 www.kueppersbusch.at ·...
Need help?
Do you have a question about the IKE 257-7-2T and is the answer not in the manual?
Questions and answers