Kuppersbusch IKE2460-1 User Manual
  1. Manuals
  2. Brands
  3. Kuppersbusch Manuals
  4. Refrigerator
  5. IKE2460-1
  6. User manual
Kuppersbusch IKE2460-1 User Manual

Kuppersbusch IKE2460-1 User Manual

Refrigerator
Hide thumbs Also See for IKE2460-1:
Table of Contents

Advertisement

Quick Links

Download this manual
User manual
Refrigerator
IKE2460-1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the IKE2460-1 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Kuppersbusch IKE2460-1

Summary of Contents for Kuppersbusch IKE2460-1

  • Page 1 User manual Refrigerator IKE2460-1...

  • Page 2: Table Of Contents

    CONTENTS Safety instructions Care and Cleaning Operation What to do if… First use Technical data Daily use Installation Helpful hints and tips Environmental concerns Subject to change without notice. SAFETY INSTRUCTIONS In the interest of your safety and to ensure usable before you discard the old appli- the correct use, before installing and first ance.

  • Page 3: Care And Cleaning

    – avoid open flames and sources of igni- Care and cleaning tion • Before maintenance, switch off the appli- – thoroughly ventilate the room in which ance and disconnect the mains plug from the appliance is situated the mains socket. •...

  • Page 4: Operation

    Environment Protection ance shall be disposed according to the applicable regulations to obtain This appliance does not contain gasses from your local authorities. Avoid dam- which could damage the ozone layer, aging the cooling unit, especially at the in either its refrigerant circuit or insula- rear near the heat exchanger.

  • Page 5: Helpful Hints And Tips

    Positioning the door shelves To permit storage of food packages of vari- ous sizes, the door shelves can be placed at different heights. To make these adjustments proceed as fol- lows: gradually pull the shelf in the direction of the arrows until it comes free, then reposi- tion as required.

  • Page 6: What To Do If

    charging must therefore only be carried Many proprietary kitchen surface cleaners out by authorized technicians. contain chemicals that can attack/damage the plastics used in this appliance. For this Periodic cleaning reason it is recommended that the outer The equipment has to be cleaned regularly: casing of this appliance is only cleaned with •...
  • Page 7 Problem Possible cause Solution The appliance does not The appliance is switched off. Switch on the appliance. operate. The lamp does not operate. The mains plug is not connected Connect the mains plug to the to the mains socket correctly. mains socket correctly.

  • Page 8: Technical Data

    Replacing the lamp 1. Disconnect the mains plug from the mains socket. 2. Remove the screw from the lamp cov- 3. Remove the lamp cover (refer to the il- lustration). 4. Replace the used lamp with a new lamp of the same power and specifical- ly designed for household appliances.

  • Page 9: Electrical Connection

    Electrical connection ance to a separate earth in compliance with current regulations, consulting a qualified Before plugging in, ensure that the voltage electrician. and frequency shown on the rating plate The manufacturer declines all responsibility correspond to your domestic power supply. if the above safety precautions are not ob- The appliance must be earthed.

  • Page 10: Door Reversibility

    Door reversibility The door of the appliance opens to the right. If you want to open the door to the left, follow these steps before you install the appliance: 1. Loosen and remove the upper pin. 2. Remove the door. 3.
  • Page 11 Install the appliance in the niche. Push the appliance in the direction of the arrow (1) until the upper gap cover stops against the kitchen furniture. Push the appliance in the direction of the arrow (2) against the cupboard on the op- posite side of the hinge.
  • Page 12 Remove the correct part from the hinge cover (E). Make sure to remove the part DX, in the case of right hinge, SX in oppo- site case. Attach the covers (C, D) to the lugs and the hinge holes. Attach the hinge covers (E) to the hinge. Disconnect the parts (Ha), (Hb), (Hc) and (Hd).
  • Page 13 Install the part (Ha) on the inner side of the ca. 50 mm kitchen furniture door. 90° 21 mm 90° ca. 50 mm 21 mm Push the part (Hc) on the part (Ha). Open the appliance door and the kitchen furniture door at an angle of 90°.

  • Page 14: Environmental Concerns

    Remove the brackets and mark a distance of 8 mm from the outer edge of the door 8 mm where the nail must be fitted (K). Place the small square on the guide again and fix it with the screws supplied. Align the kitchen furniture door and the ap- pliance door by adjusting the part (Hb).
  • Page 16 212720473-00-3132013...

Table of Contents