Larson Electronics IND-AR-WMS-FUVC-EX-18-1L-V1 Instruction Manual

Advertisement

(1) 40W 222nm Excimer Lamp - Aluminum/Indoor Use
Thank you for your purchase of the Larson Electronics IND-AR-WMS-FUVC-EX-18-1L-V1.
EPA Reg. No 98409-1
EPA Est. No. 98409-TX-1
WARNING:
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
CRITICAL SAFETY INSTRUCTIONS:
INSTALLATION SHOULD ONLY BE CONDUCTED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH NEC AND ANY
RELEVANT LOCAL BUILDING CODES.
RISK OF FIRE OR ELECTRIC SHOCK. FIXTURE INSTALLATION REQUIRES KNOWLEDGE OF FIXTURE'S ELECTRICAL
SYSTEMS. IF NOT QUALIFIED, CONTACT A QUALIFIED ELECTRICIAN.
BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.
MAKE SURE THE SUPPLY VOLTAGE IS THE SAME AS THE FIXTURE'S RATED VOLTAGE.
TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT EXPOSE WIRING TO EDGES OF SHEET METAL OR SHARP
OBJECTS. SUITABLE FOR DAMP LOCATIONS.
IMPORTANT
READ CAREFULLY BEFORE INSTALLING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE.
THE
NATIONAL ELECTRICAL CODE AND ALL APPLICABLE LOCAL CODES. PROPER GROUNDING IS REQUIRED FOR
SAFETY.
WE STRONGLY ENCOURAGE ONLY A LICENSED ELECTRICIAN INSTALL, OPERATE AND MAINTAIN THIS
PRODUCT. IF YOU ARE NOT QUALIFIED OR UNFAMILIAR WITH ANY ASPECT OF THIS INSTRUCTION
SHEET, CONSULT AN ELECTRICIAN. THERE ARE NO SERVICEABLE PARTS INSIDE.
WARNING: MAKE SURE POWER IS TURNED OFF BEFORE STARTING THE
INSTALLATION OR PERFORMING ANY MAINTENANCE.
RISK OF FIRE/ELECTRIC SHOCK –
RISK OF PERSONAL INJURY –
RISK OF BURN –
ALLOW FIXTURE TO COOL BEFORE SERVICING.
WARNING:
USER SHOULD BE TRAINED IN THE PROPER USE AND MAINTENANCE OF THIS DEVICE.
CORD IS INTENDED TO ALLOW OPERATORS TO EXTEND POWER TO EQUIPMENT WHEN STATIONARY OUTLETS ARE NOT
READILY AVAILABLE.
IMPROPER USE OF THIS CORD, PLUG, AND RECEPTACLE CAN LEAD TO SERIOUS INJURIES OR DEATH TO
PERSONNEL.
PERIODIC INSPECTION OF THE CORD IS NECESSARY.
THE CORD MUST BE ROUTINELY CHECKED FOR CUTS, BREAKS, OR ANY SEVERE ABRASIONS, AND IF ANY ARE FOUND,
THE CORD MUST BE REPLACED BEFORE RESUMING USE.
UV Warning
WARNING: ULTRAVIOLET LIGHT IS HARMFUL TO EYES AND SKIN. DO NOT STARE DIRECTLY INTO THE
ULTRAVIOLET BEAM WITHOUT WEARING PROTECTIVE GEAR TO PROTECT EYES FROM LONG TERM DAMAGE.
UNPLUG LAMP BEFORE SERVICING.
The Larson Electronics IND-AR-WMS-FUVC-EX-18-1L-V1 Far-UV Sanitation Wall Sconce Light disinfects 99% of viruses, bacteria,
mold and spores in locations requiring an architectural germicidal fixture for occupied areas and indoor sites. This eye and skin safe
disinfection unit uses one 40-watt excimer lamp that emits far-UV 222 nm germicidal light. Protected by a heavy-duty aluminum
housing, the 18" light is recommended for installation in corners of restaurants, lobbies, lounges, benches and more.
Larson Electronics, LLC
18" Far-UV Sanitation Wall Sconce Light
Instruction Manual
IND-AR-WMS-FUVC-EX-18-1L-V1
DISCONNECT POWER AT BREAKER BEFORE INSTALLING OR SERVICING.
FIXTURE MAY BECOME UNSTABLE OR DAMAGED IF NOT INSTALLED PROPERLY.
Phone: (800) 369-6671
MUST
BE
WIRED
Fax: (903) 498-3364
IND-AR-WMS-FUVC-EX-18-1L-V1
IN
ACCORDANCE
www.larsonelectronics.com
WITH
THIS LINE
1 of 6

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the IND-AR-WMS-FUVC-EX-18-1L-V1 and is the answer not in the manual?

Questions and answers

Summary of Contents for Larson Electronics IND-AR-WMS-FUVC-EX-18-1L-V1

  • Page 1 ULTRAVIOLET BEAM WITHOUT WEARING PROTECTIVE GEAR TO PROTECT EYES FROM LONG TERM DAMAGE. UNPLUG LAMP BEFORE SERVICING. The Larson Electronics IND-AR-WMS-FUVC-EX-18-1L-V1 Far-UV Sanitation Wall Sconce Light disinfects 99% of viruses, bacteria, mold and spores in locations requiring an architectural germicidal fixture for occupied areas and indoor sites. This eye and skin safe disinfection unit uses one 40-watt excimer lamp that emits far-UV 222 nm germicidal light.
  • Page 2: Installation

    • 2 x Sheet Rock Anchors • Junction box (user provided) INSTALL INSTRUCTIONS: • In the desired mounting location, install the user provided junction box before installation of the unit. Larson Electronics, LLC 2 of 6 Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com...
  • Page 3 • Attach the mounting plate of the fixture to the wall and secure it to the junction box and sheet rock anchors. Use a level to ensure it is aligned properly and drill in the mounting screws. Larson Electronics, LLC 3 of 6 Phone: (800) 369-6671 Fax: (903) 498-3364 www.larsonelectronics.com...
  • Page 4 1/8" Allen Head Wrench at the end to ensure the fixture is mounted evenly. • Once mounted and secured, connect the unit to power and use. Larson Electronics, LLC 4 of 6 Phone: (800) 369-6671 Fax: (903) 498-3364...
  • Page 5: Bulb Replacement

    REPLACEMENT PARTS The IND-AR-WMS-FUVC-EX-18-1L-V1 is designed to provide years of reliable performance. Should the need for replacement parts arise, please contact Larson Electronics. THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.
  • Page 6: Operation Precautions

    THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS. SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT SALES@LARSONELECTRONICS.COM OR BY PHONE AT 1-800-369-6671 FOR FURTHER ASSISTANCE.

Table of Contents