Functions; Tripping In The Event Of Overload; Conditions; Table 14 Channel Statuses - WAGO 787-3861/200-1000 Product Manual

Functions

4 Functions

4.1 Tripping in the Event of Overload

Note
Wait for temperature to return to normal!
If a channel has tripped due to a short circuit or overload, it is necessary to wait until the
temperature returns to its normal range before switching the channel back on.
The product checks whether the output current is greater than the nominal current set-
ting. As soon as the output current exceeds this nominal current, the channel is switched
off. The tripping time depends on the magnitude of the overcurrent. The figure below
shows the corresponding tripping times:

4.2 Conditions

State
Status 0
Status 1
18 Product manual | Version: 1.0.0
Electronic Circuit Breaker
Channel LED State
Switched off Off
Switched on Green
787-3861/200-1000
Figure 4: Trip Characteristic
Table 14: Channel Statuses
Explanation
Product initialization (boot
process)
Load current < 90 % of
nominal current