Table of Contents
Advertisement
ASSEMBLY
Before you begin, make sure you have carefully
e As you assemble the weight bench, make sure
read, and fully understand the following infor-
that all parts are oriented exactly as shown in the
mation and instructions:
drawings.
e Assembly requires two people.
`
e Tighten all parts as you assemble them, unless
instructed to do otherwise.
e Place all parts of the weight bench in a cleared
area and remove the packing materials; do not
THE FOLLOWING TOOLS (NOT INCLUDED) ARE
dispose of the packing materials until assembly
REQUIRED FOR ASSEMBLY:
is completed.
|
One (1) adjustable wrench
Read through each assembly step before begin-
One (1) standard screwdriver ==)
ning,
One (1) rubber mallet
For help identitying the small parts used in
Lubricant, such as grease or petroleum jelly,
assembly, refer to the PART IDENTIFICATION
and soapy water are also needed.
CHART on page 5. Note: Some small parts may
have been pre-attached for shipping purposes. if
Assembly will be more convenient if you have the
. a part is not found in the parts bag, check to see
following tools: A socket set, a set of open-end or
if it has been pre-attached.
closed-end wrenches, or a set of ratchet wrenches.
1. Before you begin, be sure you have read the
instructions at the top of this page.
Press a 11 2" Square Inner Cap (21) into each
side of the "H"-Frame (1).
Attach the Cross Brace (9) and the two "L"-
Brackets (12) to the lower end of the "H"-Frame (1)
with two 5/16" x 2 1/4" Bolts (22) and two 5/16"
Nylon Locknuts (25) as shown.
Attach the upper ends of the "L'-Brackets (12) to
the "H"-Frame (1) with the two 5/16" x 2" Bolts (16)
and two 5/16" Nylon Locknuts (25).
2.
Press a 1 1/4" Square Inner Cap (29) into each
end of the Stabilizer (3).
Press two 1" Round Inner Caps (24) into the bot-
tom of the Stabilizer (3).
Attach the Stabilizer (3) to the Main Frame (2) with
the two 1/4" x 1 3/4" Carriage Bolts (27) and two
1/4" Nylon Locknuts (28).
Advertisement
Table of Contents
