Table of Contents
Advertisement
3.
Attach the Main Frame (2) to the "H"-Frame (1) with
two 5/16" x 2 1/4" Bolts (22) and two 5/16" Nylon
Locknuts (25).
Attach the Diagonal Brace (8) to the Main Frame
(2) with the 5/16" x 1 3/4" Bolt (15) and a 5/16"
Nylon Locknut (25).
|
Attach the Diagonal Brace (8) to the Cross Brace
(9) with the 5/16" x 3/4" Bolt (17) and a 5/16" Nylon
Locknut (25).
Attach one Backrest Bracket (5) to the Backrest (6)
with two 1/4" x 3/4" Machine Screws (13). Attach
the other Backrest Bracket to the Backrest with
one 1/4" x 3/4" Screw (13). A second 1/4" x 3/4"
Screw (13) will be attached at the end of this
assembly step.
Slide the ends of both Backrest Brackets (5) onto
the pins on the Main Frame (2) (see the inset draw-
ing).
Attach the free end of the Backrest Bracket (5) to
the Backrest (6) with a 1/4" x 3/4" Screw (13).
« Attach the Seat (1 1) to the brackets on the Main
Frame (2) with two 1/4" x 3/4" Screws (13). Make
sure that the seat is turned so the widest end is on
the side shown.
Attach the 11 3/4" Weight Tube (19) to the Leg
Lever (4) with the 5/16" x 1 3/4" Bolt (15) and a
5/16" Nylon Locknut (25).
Press a 1" Round Inner Cap (24) into the indicated
end of the 11 3/4" Weight Tube (19). Press the 1"
Angled Round Cap (20) onto the Weight Tube.
Press a 1 1/4" Square Inner Cap (29) into the indi-
| cated end of the Leg Lever (4).
Apply lubricant to the 3/8" x 2 1/4" Bolt (14). Attach
the Leg Lever (4) to the Main Frame (2) with the
3/8" x 2 1/4" Bolt (14) and a 3/8" Nylon Locknut
(18). Do not overtighten the Nylon Locknut. The
Leg Lever must pivot freely.
Wide End
Advertisement
Table of Contents
