Figure 9 Lan; Table 6 Lan - ZyXEL Communications NXC-8160 User Manual

Figure 9 LAN

The following table describes the labels in this screen.

Table 6 LAN

LABEL
LAN
IP Address
IP Subnet Mask
VLAN (0-4095)
2nd IP Address
2nd IP Subnet
Mask
2nd VLAN (0-
4095)
Default Gateway
System Name
Apply
Reset
NXC-8160 User's Guide
DESCRIPTION
You can pre-configure two LAN IP addresses, but only one is in use at a time.
192.168.1.10 is the default IP address.
Type the IP address of your NXC-8160 in dotted decimal notation.
Enter the subnet mask that specifies the network number portion of an IP address.
Enter the VLAN identification number (between 0 and 4095) for the LAN IP
address. Otherwise, leave this field blank.
The LAN IP address's VLAN ID should be unique and cannot be in the same VLAN
group as an SSID. That means if you enable VLAN, wireless clients (connected to
an SSID on the NXC-8160) cannot communicate with the LAN IP address to
configure the NXC-8160. With VLAN, an SSID can still access the Internet through
the NXC-8160.
Note: All centralized configuration members and the master NXC-
8160 should belong to the same VLAN group.
Enter a second IP address as the NXC-8160's backup IP address. It should be in a
different subnet from the primary one.
Enter the subnet mask that specifies the network number portion of the second IP
address.
Enter the VLAN ID of the second IP address. Otherwise, leave this field blank.
Enter the IP address of the gateway.
Choose a descriptive name for identification purposes. It is recommended you
enter your computer's "Computer name" in this field. This name can be up to 30
alphanumeric characters long. Spaces are not allowed, but dashes "-" and
underscores "_" are accepted.
Click Apply to save your changes back to the NXC-8160.
Click Reset to begin configuring this screen afresh.
Chapter 3 LAN Screen
39