Generator Preparation - Wen DF8000X Instruction Manual

8000w electric start dual fuel generator

Hide thumbs

Table Of Contents

Table of Contents

REMOVING THE SHIPPING BRACKETS

Your generator is shipped with two shipping brackets in order to prevent machine damage during shipping. Make

sure to remove the shipping brackets before operating your generator. Failure to do so could lead to engine damage.

1. With the help of another person, place generator on an elevated platform such as table or workbench. Make sure

the generator is stable. Remove the shipping brackets. Do not tilt the generator as there may be remaining oil inside

the crankcase from testing.

The following section describes the necessary steps to prepare the generator for use. If you are unsure about how

to perform any of the steps, please call 1-847-429-9263 M-F 8-5 CST for customer service. Failure to perform these

steps properly can damage the generator or shorten its life.

STEP 1 - ADD / CHECK OIL

The generator is shipped without oil. User must add the proper amount of oil before operating the generator for the

first time. The oil capacity of the engine crankcase is 30.4 fl. oz. (0.90 L).

ENGINE OIL RECOMMENDATIONS

Select good quality detergent oil bearing the American Petroleum Institute (API) service classifications SJ, SL,

or SM (synthetic oils may be used). Select the SAE viscosity grade of oil that matches the expected operating

temperature.

-20

°F

°C

-20

-30

To add oil, follow these steps:

1. Place the generator on a level surface. Make sure the en-

gine is off before adding or checking oil.

CAUTION: Keep the generator level! Tilting the generator

to assist in filling will cause oil to flow into the wrong

areas of the engine and cause damage.

2. Turn the dipstick (Fig. 1 - 1) counterclockwise until it is

unscrewed from the engine.

3. Using an oil funnel or appropriate dispenser, slowly add

oil into the oil fill, being careful not to overfill the unit. Fill the

crankcase until you can see the oil coming halfway up the oil

fill threads (Fig. 2).

4. Reinstall the oil dipstick and firmly tighten it. Wipe clean

any spilled oil.