Dell DR4300e Owner's Manual page 9

Item Indicator, Button, or
Connector
2 Power button
3 NMI button
4 Information tag
5 Hard drives
6 USB management port/
iDRAC Direct
7 Video connector
8 Quick Sync (optional)
Icon Description
NOTE:
• If the system stops responding during
POST, press and hold the system ID button
(for more than five seconds) to enter BIOS
progress mode.
• To reset the iDRAC (if not disabled in F2
iDRAC set up) press and hold the button
(for more than 15 seconds).
Enables you to know the power status of the
system. The power indicator turns on when the
system power is on. The power button controls
the power supply output to the system.
NOTE: On ACPI-compliant operating systems,
when the power button is used to shut down
the system, the operating system performs a
graceful shut down the system power is
turned off.
Enables you to troubleshoot software and device
driver errors when running certain operating
systems. This button can be pressed by using the
end of a paper clip.
NOTE: Use this button only if directed to do
so by qualified support personnel or by
instructions in the operating system's
documentation.
Contains system information such as service tag,
NIC, MAC address for your reference. The
information tag is a slide-out label panel.
Up to twelve 3.5-inch hot-swappable hard drives.
The USB management port is USB 2.0 compliant.
Enables you to connect USB devices to the system
or provides access to the iDRAC Direct features.
For more information, see the Integrated Dell
Remote Access Controller User's Guide at
Dell.com/idracmanuals.
Enables you to connect a display to the system.
Indicates a Quick Sync enabled system. The Quick
Sync feature is optional and needs a Quick Sync
bezel. This feature allows management of the
system by using mobile devices. This feature
aggregates hardware or firmware inventory and
various system level diagnostic and error
information that can be used in troubleshooting
the system. For more information, see the
9