Table of Contents
Advertisement
4 Check
Total Physical Memory
If your RackStation does not recognize the memory or does not start up correctly, please make sure the memory
was correctly installed.
Remove a RAM Module from RackStation
1 Follow steps 1 and 2 of "Install a RAM Module" to remove the cover from your RackStation.
2 To remove the RAM module, follow the steps below:
a Release the ejectors on the memory slot by pushing them toward the sides.
b Hold the memory module by the edges and remove it from the slot.
3 Replace the top cover, slide it into place, and tighten the two back screws.
Add a Network Interface Card to RackStation
Your RackStation contains a PCI Express expansion slot which allows you to install a 10G/E or Gigabit network
interface card for LAN port expansion.
longer bracket (for PC usage) on your network interface card with the shorter bracket (for RackStation usage).
---------
1
For more information about supported 10G/E or Gigabit network interface cards, visit
11 Chapter 2: Hardware Setup
in
Main Menu
>
System
Information.
RackStation
RS10613xs+
8192 MB
1
Before installing the card on your RackStation, you must replace the
www.synology.com.
Advertisement
Table of Contents
