Add A Network Interface Card On Rackstation - Synology RackStation RS3412RPxs Quick Installation Manual

Remove the RAM Module from RackStation
1 Follow step 1 to 2 of the "Install the RAM Module" section to open the cover of your RackStation.
2 Remove the RAM module.
a Open the ejectors on the memory slot and push them out to the sides.
b Hold the memory module by its notches and remove it from the slot.
3 Replace the top cover. Replace and tighten the 2 screws you removed in step 1.

Add a Network Interface Card on RackStation

Your RackStation has a PCI Express expansion slot which allows you to install 10G/E or Gigabit network
interface card for LAN port expansion.
interface card with the short bracket (suited for 2U RackStation) before installing the card on your RackStation.
To replace the long bracket with the short one:
1 Unscrew the 2 screws in the long bracket on your network interface card, and then remove the bracket.
---------
1
For more information about supported 10G/E or Gigabit network interface cards, visit www.synology.com.
10 Chapter 2: Hardware Setup
1
You need to replace the long bracket (suited for PC) in your network