Intex 126662GS Owner's Manual page 18

Table of Contents

Advertisement

TROUBLESHOOTING GUIDE (continued)
LED PANEL
CODE
LED Panel Code Flash & Alarm On (NOTE: Always turn off the power before cleaning and servicing).
1. Filter pump not attached to
system and/or switch on.
2. Circulation line is blocked.
3. Incorrect inlet and outlet hose
direction.
4. Scale on fl ow sensor pins inside the
titanium electrode.
5. Electrode cord is loose.
6. Inner timer confl ict between fi lter pump
and saltwater system.
1. Dirt or scale on titanium plates.
2. Low salt level / No salt.
3. Electrolytic cell cord is loose.
4. Possible electrolytic cell failure.
1. High salt level.
2. Water temperature > 35ºC.
3. Titanium electrode failure.
If you continue to experience diffi culty, please contact our Consumer Service Department for
assistance. See separate "Authorized Service Centers" sheet.
SAVE THESE INSTRUCTIONS
(130GS) MINI SALTWATER SYSTEM ENGLISH 7.5" X 10.3" PANTONE 295U 06/09/2022
PROBLEM
IMPORTANT
SOLUTION
• Ensure a fi lter pump with the correct fl ow
rate is attached and operating. See "Setup
Instruction".
• Remove the black hat-like plugs from the
pool strainer connectors.
• Clear your fi lter cartridge and cell from debris
and dirt. See "Maintenance".
• Release all trapped air in the circulation line.
See the fi lter pump manual.
• Check the direction of the inlet and the outlet
hose. Reverse the hoses if necessary. See
" Set Up Instructions".
• Clean the titanium electrode. See
"Maintenance" section.
• Plug the cord into the electrode and tighten
the plug collar fi rmly.
• Reset both timers on the fi lter pump
and saltwater system. See "Operating
Instructions".
• Remove primary electrolytic cell for
inspection. Clean it if necessary. See
"Maintenance".
• Add salt. See "Salt & Pool Water Volumes".
• Ensure that the cell cord is plugged fi rmly
into the cell housing receptacle.
• Contact Intex Service Center. Replace the
cell if needed.
• Partially drain the pool and refi ll it with fresh
water. See "Salt & Pool Water Volumes".
• Contact Intex Service Center.
• Contact Intex Service Center.
130
English
GS
Page 17

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cs2220gKrystal clear qs200

Table of Contents