Table of Contents
Advertisement
g-
h.
i.
Measurement function
(level meter,
distortion meter,
or S/N
meter)
Indicator ranging
(manual or automatic)
Input level meter range
Indicator range
On/off of LPF, HPF,
and WEIGHTING
(if fitted)
42)
Controls that can be set mechanically
(MODIFY digit select switch
(
27
),
amplitude unit select switch
(dB/dBm)
(29) ,
and KEF ADJ
control
(id))
cannot be stored.
They can be operated at any time
43)
Do setting of level measurement of the normal operation according
to steps 15)
to 28), and store the setting according to step 40),
0 0
specifying addresses
A~j.
j
1 | to
0
'
and
to
44) Return to normal operation.
Do setting for distortion measurement
according to steps 29)
to 39),
and store the setting in addresses
0 0 to 0 0-
45) Return to normal operation and do setting for S/N measurement
according to steps 34)
to 39),
and store the setting in addresses
0 0
'
to
D
46) Press the RCL key to recall the contents stored at address | A
J [
l~j
in step 43).
The displays on the front panel indicate the contents
at address A-l.
to | D | | 4 | in sequence.
Ensure that
47) Recall all addresses
all settings stored in steps 43)
to 45)
are recalled.
48)
Data stored in the 16 memory registers
(addresses A-l to D-4)
are
saved, even after power to the analyzer is turned off.
Confirm
this by turning the POWER switch (^l) off and on.
49) The analyzer was designed so that the state set immediately before
power is turned off is restored when the analyzer is powered up
again.
Confirm this also.
OJ
O
CM
O
I
CO
CO
V
4-20
Advertisement
Table of Contents
