Table of Contents
Advertisement
3.5 Interconnection with Other Equipment
Plug the power cable into a properly wired receptacle before
connecting the instrument to the other equipment.
The interconnections are made with BNC connectors and rear panel
2-4-pin connector.
Particular consideration should be required for floating connection.
See section 4.4 for detail.
NOTE:
The 24-pin connectors should only be connected to the remote
control fixture prepared specifically for this instrument.
3.6
Mounting on the Bench
The instrument cabinet has plastic feet and fold-away tilt stand.
The tilt stand raise the front of the instrument for easier
operation of the front panel controls.
Stacking with other instruments may be allowed only when it does
not cause degradation of the performances due to interference such
as vibration or electromagnetic induction.
3.7
Rack Mounting
The VP-7721A may be rack mounted by using the Rack Mount Kit H100
(Part number VQ-069H10).
The kit contains two rack flanges, four
screws and conversion instrucitons.
It will fit 480 mm wide racks
conforming JIS C 6010.
Advertisement
Table of Contents
